USGI M14 EBR Trigger Shoe Installation Instructions:

Installation Instructions:

1. Clean the trigger, the interior of the shoe, both set screws and the threaded holes with rubbing alcohol.
2. Apply a bead of Blue Loctite to the inside cavity of the shoe using the Loctite as bedding material.
3. Fit the shoe to the trigger. Insert one screw to hold the shoe in place, adjust as needed.
4. Insert the second screw and tighten both.
5. Please allow a full 24 hours for the Loctite to set-up.

NOTE: We use 3-48×3/32 cup point alloy steel set screws

Short video